Guide · Manufacturing & plant hire ·

Inspecting work and lifting equipment: PUWER, LOLER and Irish rules

What needs inspecting, what needs a thorough examination and how often, who can do it, what the report must say and how long to keep it. With the Northern Ireland and Republic of Ireland rules, and who does what when equipment is hired.

6 months Between thorough examinations of lifting accessories and equipment that lifts people, unless a scheme says otherwise

In Great Britain, the Provision and Use of Work Equipment Regulations 1998 (PUWER) cover all work equipment, from hand tools to mobile plant, and the Lifting Operations and Lifting Equipment Regulations 1998 (LOLER) add duties for anything that lifts or lowers a load, from cranes to slings and shackles. The duties fall on whoever owns, operates or controls the equipment, and on any business whose staff use it. Northern Ireland and the Republic of Ireland are covered at the end.

Checks, inspections and thorough examinations

  • Pre-use checks: quick visual and function checks by the operator, such as a cable’s condition or whether brakes and lights work. Usually not recorded.
  • Inspection: a PUWER duty where safety depends on how equipment is installed, or where wet, abrasive or corrosive work wears it down. Risk assessment and the manufacturer’s advice set how often. The result is recorded.
  • Thorough examination: a LOLER duty: a systematic, detailed examination of lifting equipment by a competent person, at set maximum intervals, with a written report.
  • Maintenance: a separate PUWER duty to keep equipment in good repair. An examination does not replace it.

On a forklift truck, the LOLER examination covers the lifting parts, such as the chains and forks, while the brakes, lights and other parts fall under a PUWER inspection. Both can be done on one visit.

Cold metal power presses have fixed PUWER intervals: a thorough examination every 12 months with only fixed guards, otherwise every 6, and a signed guard check by an appointed person after tool setting and within the first four hours of each shift.

When lifting equipment needs a thorough examination

  • Before first use: unless it is new, with a declaration of conformity under 12 months old, and was not assembled on site.
  • After installation: where safety depends on how it is installed, and again after each assembly at a new site.
  • In service: at the maximum intervals below, or under an examination scheme.
  • After exceptional circumstances: such as damage, a failure or a long spell out of use.
Maximum intervals between in-service thorough examinations. Sources: LOLER regulation 9 and the General Application Regulations 2007, Schedule 1.
EquipmentGB and NIRepublic of Ireland
Lifting accessories (slings, chains, shackles, eyebolts)6 months6 months
Equipment for lifting people, such as MEWPs6 months6 months
Cranes12 months12 months, with a test every 4 years for mobile cranes
Forklift trucks and telehandlers12 months, or 6 if used to lift people12 months, or 6 if used to lift people
Can a scheme change the interval?Yes, shorter or longerNo longer intervals; the examiner can set shorter ones

Examination schemes

In Great Britain and Northern Ireland, an examination scheme can replace the fixed intervals. It names the parts to examine, the methods and the intervals, and can cover a group of similar items, such as all the slings in one factory. A longer interval needs a rigorous risk assessment. Anyone competent can write it, including the user, owner or manufacturer. Review it at each examination and after any incident that changes the risk, and keep a written copy.

Who counts as a competent person

GB law does not define the term. HSE’s Approved Code of Practice describes someone with enough practical and theoretical knowledge and experience of the equipment to find defects and judge how serious they are. They can be staff or from an outside firm, but must be impartial and should not be the person who maintains the equipment. A PUWER inspector needs to know what to look at, what to look for and what to do about a problem, which someone in-house often does.

Reports and defects

The competent person sends a written or electronic report to the employer and to anyone the equipment was hired or leased from. There is no set form, but it must cover the items in Schedule 1 to LOLER, including the safe working load, any dangerous defects, the repairs needed and the date of the next examination. HSE guidance says it should normally arrive within 28 days.

  • Dangerous defects: the competent person tells you at once of any defect that is or could become dangerous, and it goes in the report even if fixed on the spot.
  • Out of use: the equipment must not be used until the defect is put right, or beyond any repair deadline the report sets.
  • Copy to the regulator: where there is an existing or imminent risk of serious injury: HSE or the local authority in Great Britain (HSE for hired or leased equipment), and HSENI for hired or leased equipment in Northern Ireland.

How long to keep the records

Records can be electronic if protected from unauthorised changes. Source: LOLER regulation 11 and PUWER regulation 6.
RecordKeep it (GB and NI)
Examination before first useUntil you stop using the equipment (accessories: 2 years)
Examination after installation or assemblyUntil the equipment stops being used at that site
In-service or exceptional examinationUntil the next report, or 2 years, whichever is later
Inspection record (PUWER or LOLER)Until the next inspection is recorded
Declaration of conformityFor as long as you use the equipment

Hire firms and hirers

Under PUWER and LOLER, equipment must not leave a business, or be used by another, without physical evidence that its last required inspection or thorough examination was done: usually a copy of the report, or a tag, label or colour code for small items. HSE’s code of practice then divides the duties.

  • The hire firm: sends the evidence with the equipment, and keeps duties as far as it controls how the equipment is used or maintained.
  • The hirer: checks the evidence before use, runs the lift safely, and makes sure periodic examinations happen on time. It can agree that the hire firm does them, but the duty stays with the hirer.
  • Long-term hire: the two should agree who arranges examinations, and putting it in writing helps. Inspections, pre-use checks and defects stay with the hirer.
  • Contract lifts: where a contractor plans the lift and supplies the crane and crew, the contractor is responsible for the crane and a safe lift.

Northern Ireland

PUWER and LOLER have Northern Ireland versions, both made in 1999, which match the GB rules on intervals, schemes, reports, records and evidence travelling with equipment. HSENI enforces them and lists HSE’s PUWER code of practice as approved for use in Northern Ireland. A hire fleet working on both sides of the border has to meet both sets of rules.

Republic of Ireland

The General Application Regulations 2007, Part 2, Chapter 2, apply, enforced by the Health and Safety Authority (HSA). The main differences:

  • Fixed intervals: Schedule 1 sets a maximum period for each kind of equipment, with no scheme route to a longer one. The examiner can set a shorter period, giving the reason in writing.
  • Testing: mobile cranes and winches every 4 years, tower cranes after each assembly, and any lifting equipment after a substantial alteration or repair affecting strength or stability.
  • Reports to the HSA: where the examiner advises that work stops at once, they send the HSA a copy of the report within 20 days.
  • Records: inspection results are kept for 5 years, open to users. Examination reports stay where the equipment is based, or on the machine and at the owner’s address for mobile plant, and employers keep a register of lifting equipment and accessories, each with an identifying number.
  • Hire firms: anyone who hires out lifting equipment has its own duty to have it examined and tested and to keep the reports and register.
  • Competent person: defined in the Safety, Health and Welfare at Work Act 2005 as someone with enough training, experience and knowledge for the task, given the size and hazards of the business.

This guide is general information, not legal advice. Check the current position with HSE, HSENI or the Health and Safety Authority, and the regulations on legislation.gov.uk and the Irish Statute Book, before relying on it.

Sources